RC Water-Proofing Service

Waterproofing your electronics is vital, especially for those of you who are Scalers and Crawlers that like to test you RC in water, mud and snow. A decent amount of waterproofing is also ideal just to keep the "dirt and dust out of the electrical components".  We like to use the term “Environment Protection”.  Our Environment Protection Waterproofing Service includes waterproofing your ESC, Receiver and Servo for only $35, which is a better deal than paying for each separately. 

RC Servo Water-Proofing

Many people believe that servos function just like small motors with gears, and therefore don’t need to be protected, just like your RC motor.  Kind of makes sense, until you realize that there is a circuit board that modulates servo rotation.  Not to mention its hard to get water out, once it has entered the servo box. Servo only waterproofing is only $15.

RC Receiver Water-Proofing

The receiver is the most important component that you can ever waterproof.  This is the hub of all communication between your controller, receiver, speed control, and the servos.  Not to mention, it is one of the more pricey electrical components to replace.  Many receivers in RC cars come in a receiver box, where the lines run in and out of the box in nice neat little holes cut out.  It's always good to waterproof the box because they tend to leak. If your receiver is exposed to the elements its a must to seal them, We seal both the box and the receiver as part of our service. Receiver only waterproofing is only $15.

RC Motor Water-Proofing

A brushed motor doesn’t need any waterproofing at all!  Underwater submersion is even a method that many folks use to break in their electric motors.  Just make sure that it is fully dried after it gets wet or else you are asking for corrosion problems.  Remember that all bearings within the motor require oil after getting drenched in water or snow. 

RC ESC (Electric Speed Controller) Water-Proofing

The ESC should also be a high priority item that you should be waterproofing.  While just as important as the receiver, it is a little more cumbersome to waterproof.  Why? Because we can’t simply encase it in a balloon or some small container.  As you know, the speed controller gets really hot and requires good ventilation.  Now, the point here is to preserve your electronics, not damage them; so lets us do it right!  ESC waterproofing is only $20.

RC Environment Protection Service: $35 For All 3 Key Electronics

RC ECS Waterproofing
ESC Water-Proofing
RC Receiver Waterproofing
Receiver Water-Proofing
RC Servo Waterproofing
Servo Water-Proofing